Components - Meister i-drill MAS36ip3 Traduction Du Manuel D'utilisation Original

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
5450210-Akku-Schra_man 11.03.16 08:41 Seite 39
Noise emission/vibration
Noise emission
L
: 68 dB(A), L
pA
WA
Measuring inaccuracy:
K
: 3 dB(A), K
: 3 dB(A)
pA
WA
Hand/arm vibrations
2
a
: 0,70 m/s
;
h
Measuring inaccuracy K: 1,5 m/s
Noise/vibration information
Measured values determined in
accordance with EN 60745-1,
EN 60745-2-2.
The specified vibration emission value
was measured in accordance with a
normed test procedure and can be used
in order to compare one electrical tool
with another.
The specified vibration emission value
can also be used for an introductory
evaluation of the influence.
CAUTION! The vibration
emission value may fluctuate
from the specified value during use of
the power tool. These fluctuations will
depend on the way in which the power
tool is used.
Try to keep the vibration loads as low
as possible. Examples of measures
that may be taken to reduce the
vibration load include wearing gloves
when using the tool and limiting the
length of the working period. All parts
of the operating cycle must be taken
into account for this purpose (for
: 79 dB(A)
2
example, also including times in which
the power tool is switched off and
times in which it is switched on, but is
running without load).
CAUTION! A certain amount of
noise is unavoidable when using
this device. Ensure you carry out
noise-intensive work during permitted
times. Maintain the quiet periods and
limit your work to the absolute
minimum.
CAUTION! The effects of noise
may cause damage to the
hearing. Only ever work with suitable
ear defenders. Anybody else in the
vicinity should thus also wear ear
defenders.
3 – Components
1 On/Off switch with integrated light
switch
2 Right and left rotation switch
3 LED working light
4 Bit holder
5 LED charging and rotational direction
display
6 Screwdriver handle
7 Charger socket
8 Mains adapter
9 Charging plug
10 Charger
11 Connection
12 Charging bay
13 Charger connection
14 Tool holder, flip-out
15 Charging contacts
39

Publicité

Table des Matières
loading

Table des Matières