Final Checks - GiBiDi SC24 Instructions Pour L'installation

16
UK
11 - MANUAL MANOEUVRE
If the gate is unlocked and moved manually, position the gate into the stroke defined by the limit switches before locking the operator
again.

12 - FINAL CHECKS

• Check the electrical connections: an improper connection may be harmful to both the control unit and the operator.
• Check the correct position of the limit switches.
• Always preset the mechanical stops in opening and closing.
• Check the correct operation of photocells and safety devices.
• Check that the motors are blocked and ready to work with GATE HALFWAY POSITION.
• Remove possible obstacles in the operating area of the gate.
• Check that the direction of gate motion is correct:
- take off the power supply from the control unit.
- power the control unit.
- give a START command.
- check that the gate is opening, otherwise take off the power supply from the control unit and invert the wires of terminal M3.
• Check the correct operation of the automation.
13 - FLASHING LIGHT SIGNALLING SUMMARY
Device
Photo intercepted at rest in presence of START
command ( DIP5 = ON )
Test photo failed
Frame intercepted before the motion
Test frame 8K2 failed (terminal 13)
Test frame 8K2 failed (terminal 9)
Thank you for choosing GIBIDI.
READ CAREFULLY THESE INSTRUCTIONS BEFORE PROCEEDING WITH INSTALLATION.
WARNINGS:
This product has been tested by GI.BI.DI. for full compliance with the requirements of the directives in force. GI.BI.DI. S.r.l. reserves
the right to change the technical data without prior notice in relation to product development.
DISPOSAL: GI.BI.DI. advises recycling the plastic components and to dispose of them at special authorised
centres for electronic components thus protecting the environment from polluting substances.
Signalling
5 fast flashings
4 slow flashings
3 slow flashings
2 slow flashings
1 slow flashing
SC24
Effect
When released, it opens
Door blocked
Door blocked
Door blocked
Door blocked