GiBiDi SC24 Instructions Pour L'installation page 14

14
UK
8 - DIP SWITCH SW1
DIP Function
DIP3 PRE-FLASHING
ENERGY SAVING
DIP4 SAFETY DEVICES
TEST
PHOTOCELL
DIP5
IN OPENING
AUTOMATIC
DIP6
RECLOSING
DIP7 DECELERATION
FAST
DIP8
RECLOSING
DIP9 --
TERMINAL 9
DIP10
FUNCTION
Status Description
Enables the pre-flashing of 3 seconds before the activation of the motor in
ON
opening and closing.
OFF Disables the pre-flashing.
Enables the TEST of the devices connected to the terminals (9)-(12)-(13):
if the devices are working perfectly, the cycle can start,
otherwise some prolonged flashings will indicate the anomaly.
• Terminal (12 - "PHOTO"): power the photocells' transmitters by the
terminal (18) and the receivers by the terminal (17).
At the beginning of the manoeuvre, the current will be cut to the transmitters
ON
for 1 second and then restored to check its right operation.
• Terminal (13 - "SAFETY") and (9 if DIP10=ON ):
the resistive value 8K2 Ω is checked
Enables ENERGY SAVING:
There will be some tension on terminal (18) only during the manoeuvre.
At rest the leds will be off.
Disables the safety devices test.
OFF
Disables ENERGY SAVING
When the photocell is intercepted, during both opening and closing, the gate
ON motion is locked until the photocell is freed.
Subsequently there is always an opening phase.
Photocell enabled only during closing,when it is intercepted the gate opens.
OFF
ON Disables automatic closing.
Enables automatic closing after the pause time adjustable by the trimmer
OFF
TR1 PAUSE from 2 to 225 seconds.
Enables the deceleration during both opening and closing, when the respective
limit switch is intercepted.
The deceleration speed is adjusted by trimmer TR3 SLOW.
ON
This function provides for use of 4 magnets.
See fig. 22 and 23.
Disables the deceleration function.
OFF
Only 2 magnets are required.
ON Reduces the pause time to 3 seconds after the intervention of the photocells.
OFF Disables the fast closing function.
--
Terminal 9 (SAFETY-STOP) works as terminal 13 (SAFETY 8K2).
ON
See Chap.5 .
Terminal 9 works as STOP 8K2.
The activation of STOP 8K2 device causes an immediate STOP of the
OFF
automatic device.
.
--
SC24