Maintenance And Environmental Protection - Meister MPH1050-1 Traduction Du Manuel D'utilisation Original

5452810-Bohrhammer_man 15.05.15 13:04 Seite 55
dependant on the pressure. A greater
pressure, thus, does not increase the
performance!
When drilling large holes, use a small
diameter drill to make a pilot hole.
Drilling in wood and metal
(Figures 16)
Insert the supplied crown gear chuck
(11) for conventional wood and metal
drills into the chuck (8) as described in
the section on changing tools. Open the
chuck using the chuck key (12) and
insert a conventional wood or metal drill
bit. Tighten the chuck with the key.
Preset the revolutions with the
adjustment wheel (4): Set the selection
lever (5) to the "Right" position. Press
the on/off switch (3) and drill using the
set highest revolutions.
CAUTION! All of the pictured
insert tools are not part of the
scope of delivery!
Screwing and removing screws
The crown gear chuck can also be used,
with a bit holder (not included), to insert
all types of screwdriver bit. To screw
screws into place, set the selection
lever (5) to the "Right" position.
CAUTION! To achieve the best
transmission of force, always
use a bit that matches the relevant
screw head!
CAUTION! To ensure that you do
not damage the screw heads,
always start with low revolutions
increase as required!
CAUTION! All of the pictured
insert tools are not part of the
All manuals and user guides at all-guides.com
scope of delivery!
To remove screws, set the selection
lever (5) to left rotation.
Start with low revolutions to ensure that
you do not damage stuck screw heads.
Increase revolutions carefully as
required.
than in right rotation!
10 – Maintenance and
• Clean the machine housing with a
• Always ensure that the ventilation
should not be disposed of in the
household waste! They are to be
collected separately, in accordance with
the 2012/19/EU directive for the
disposal of electrical and electronic
waste, and sent for proper and environ -
mentally-friendly
recycling.
Please discard power
tools no longer usable at
a local collection point. Collection
and disposal of packaging materials
separately by types complying with
local rules and regulations. For
details, please contact your municipal
authority concerned.
When in left rotation mode, the
maximum revolutions are lower
environmental
protection
damp cloth only – do not use solvents!
Then dry well. Never submerge
electrical machinery in water.
slots of the machine are kept clean.
CAUTION! Electrical and battery
operated units that no longer work
55