Safety Instructions Relating Specifically To The Equipment - Meister MPH1050-1 Traduction Du Manuel D'utilisation Original

5452810-Bohrhammer_man 15.05.15 13:04 Seite 50
unplugged (not connected to the
power source).
– The electrical capacity of your
extension cable should be at least as
powerful as the device.
– Check to make sure that the mains
power supply matches the
specifications on the type plate of the
device.
– Check walls and ceilings in order to
avoid damaging hidden cables.
– Never touch the external housing
directly after drilling. This becomes
very hot during drilling operation.
– To avoid hazards, damaged power
leads must be replaced by the
manufacturer or his customer service
representative.
6 – Safety instructions
relating specifically to
the equipment
WARNING! Read the operating
instructions to lessen the risk of
injury.
Wear ear defenders.
Wear a dust-protection mask.
Wear goggles.
• Only use the additional handle
supplied with the unit. Loss of
50
control may lead to injuries.
All manuals and user guides at all-guides.com
• Use the unit only for the applications
it is designed for.
• When operating the machine, always
hold it with both hands and ensure
that you are standing firmly.
• Sockets outside must be fitted with a
residual current circuit-breaker.
• Shavings or splinters should never be
removed when the machine is running.
• Before starting to drill into a wall,
make sure that there are no
concealed power, water or gas lines
located at the drilling position.
• Small work pieces should be secured
in such a way that they cannot be
moved by the drill when drilling.
• Before carrying out any work on the
machine, when taking a break and
when the machine is not in use,
always pull the plug out of the
socket.
• Always keep the power cable away
from the area you are working in.
• Only plug the machine into the socket
when it is switched off.
• Persons under the age of 16 may not
be permitted to operate the machine.
• Observe the general safety notes for
operating electrical tools!
• Chase and drill may accidentally be
catapulted out of the tool and cause
serious injuries.
• Before starting work, check to make
sure that the chase or drill bit is
locked into the tool.