Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7. Thread the diagonal belt through the locking
clip﹐ and then fasten the locking clip.
14
8. Refasten the locking clip.
15
!
Please check if child restraint is installed
tightly by moving the child restraint back and
forth at the vehicle belt path. Please
reference vehicle owner's manual for more
information. (Child restraint should not move
more than 25mm/1").
13
14
15
Correctly assembled vehicle belt is shown in
16
.
!
Vehicle waist belt passes through the vehicle waist belt slots﹐ as show in
!
Vehicle shoulder belt must pass through the rear-facing vehicle shoulder belt slots﹐ as shown in
!
The vehicle buckle tongue is engaged with the buckle correctly﹐ as shown in
16
ii. Securing your Child in the Child restraint
see images
-
17
22
Note
1. Infant insert is for child's protection. Child 0-6 months must use infant insert.
2. Please install the child restraint on the vehicle seat, and then place the child in the child restraint.
3. After the child is placed into the child restraint, check whether the shoulder harness straps are at the
proper height. Please refer to
images 6-7
(Height Adjustment for Head Support and Shoulder Harness
Straps).
- 1
16
.
16
- 3
16
.
3 3
- 2
.
2 2
14
Publicité
Table des Matières
