Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Youth Mode
(for Child 15–25kg / 3–7 years old)
see images
-
30
35
Reference age
3- 7 years old
Seat position
Positions 1-2 (with top triangle and a red triangle aligned
i. Converting from Toddler Mode to Youth Mode
see images
-
30
32
1. Press the red button down to disengage the buckle.
2. To remove the crotch pad﹐ first locate the elastic on the inside of the crotch pad. Pull both the elastic
and the crotch pad over the buckle to remove.
3. Remove the infant insert.
- 1
4. Detach the snaps
31
and the hook and loop fastener on the seat pad.
5. Lift the upper flap of seat pad upward and pull the lower flap forward. Then store the shoulder straps
- 3
31
and buckle tongues in their storage compartments.
6. Pull the buckle through the slot in the seat pad and then store the buckle in its storage
- 5
compartment.
31
- 1
7. Reattach the snaps
31
and the hook and loop fastener
!
To convert back to Toddler mode from Youth mode﹐ please reverse the above steps.
30
31
1
4
21
5
).
18
30
- 2
31
- 4
31
- 2
31
to recover the seat shell.
32
32
2
3
5
ii. Installation for Forward-Facing Youth Mode
see images
-
33
36
Note
1. Only use the vehicle seat belt when installing the child restraint in the forward-facing Youth mode. Do not
use the infant insert, shoulder straps or crotch strap. Please store the shoulder straps, buckle and buckle
31
tongues in their storage compartments.
!
It is not recommended to install child restraint forward facing on front seat with airbag. Please
reference vehicle owner's manual for more information.
2. Please adjust the shoulder harness straps to the proper length before storing the shoulder straps and
17
buckle in their storage compartments.
3. Please adjust the child restraint to the proper recline position (Only positions 1-2 are acceptable for
forward-facing Youth mode). Angle indication: With top triangle and a red triangle aligned
refer to
image 4
(Reclining Adjustment).
4. When installing and adjusting the vehicle belts, make sure that both the vehicle shoulder belt and the
vehicle waist belt are not twisted or the belts may not function properly.
1. Place your child in the child restraint. Check
whether the shoulder belt guides are at proper
height. Please refer to
images 6-7
(Height
Adjustment for Head Support and Shoulder
Harness Straps).
2. Install vehicle shoulder belt through vehicle
- 1
shoulder belt guide
33
and pass vehicle
waist belt through vehicle waist belt slots shown
- 2
in
33
. Engage vehicle belt tongue into
buckle.
5
. Please
33
1
1
2
22
Publicité
Table des Matières
