Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User's Guide
2.2 MENSAJES DE PANTALLA
dc x.xx
Mean the voltage of battery is x.xx V.
------
Show this as the weight over 100% FS+9e, with the ding sounding, this means over load, reduce
the weight.
AdC
As the A/D change overflowing, display shows this with the ding sounding.
-BAtLo-
The voltage is lower. You can use a short while and charge immediately.
C_End
Recharge is end.
Err-0
Overload zero of loadcell. Please re-adjust or change loadcell.
3. OPERATION GUIDE
3.1. PREPARATION
Adjust the base foot, watch the level, make the pan in horitzontal.
3.2. TURN ON OR TURN OFF
3.2.1. Turn on:
Press the ON/ZERO key, the ding sound, it displays version No. and the battery voltage level and 9, 8,
7, ..., 1, 0, the "ZERO" lamp lighting. Now the scale is in a working state.
3.2.2. Turn off:
Long-press OFF key.
3.2.3. Auto-off:
After 10 minutes in zeroing, auto-off.
3.2.4. Low voltage auto-off:
When the voltage lower than 5.6V, then power-off.
3.3. ZERO
When without taring the weight display is ≤ 4% Max. capa., press the ON/ZERO key, the display shows "0",
the zero lamp lighting.
3.4. WEIGHING
Put weight to pan.
3.5. TARE WEIGHING
Press the TARE key, it's being think the "skin" tare, the weight display is "0", the ZERO lamp off, the TARE
lamp lighting. Pick up the weight and the "skin", the weight display is negative, the ZERO lamp lighting, press
the TARE key, the TARE lamp off.
3.6. SAVE POWER FUNCTION
Zero after 40 seconds, auto save power, shows "0". Put a weight start weighing.
3.7. BATTERY INDICATE
Battery lamp: "High" means voltage higher than 6.3V, "Mid" means voltage between 6V and 6.3V, "Low" means
voltage lower than 6V.
12
All manuals and user guides at all-guides.com
Check Weight scale
Model Super SS
Publicité
Table des Matières
