Synchronising Transmitter / Receiver - SilverCrest HG00783A Instructions De Montage, D'utilisation Et Consignes De Sécurité

Remove the used batteries, if present (see fig. C2).
Insert a battery (3 V
must face upwards.
Install the rubber cover
back on to the back of the device.

Synchronising transmitter / receiver

The doorbell works on 434 MHz which is a quite common fre-
quency. To ensure that the function gets no influenced be doorbells in
the neighborhood, the transmitter and the receiver hence have to be
synchronized in regard of the encryption. Every transmitter is working
with a different encryption of the signal.
Synchronise the transmitter and receiver as follows:
As soon as the batteries are installed, the receiver enters synchro-
nizing mode for approx. 1 minute. During the synchronizing
mode, the signal indicator
You can also manually enter synchronising mode by holding the
synchronising button
The signal indicator
approx. 1 minute, to indicate that the receiver is in synchronizing
mode.
Press the chime button
in synchronise mode. If the receiver receives the signal, the steady
blue light of the signal indicator
that the synchronization is successful.
12 GB/IE
, type CR 2032). The side marked "+"
, close the holder
15
steadily lights up in blue color.
1
for approx. 3 seconds.
5
on the receiver will steadily light up for
1
of the transmitter, while the receiver is
9
flickers 6 times to indicate
1
of the transmitter
12