Safety In The Workplace - Royal Catering RCPKG-3600-R Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 50
b)
Avoid touching earthed elements such as pipes, heaters, boilers and
refrigerators. There is an increased risk of electric shock if the earthed device
is exposed to rain, comes into direct contact with a wet surface or is
operating in a damp environment. Water getting into the device increases
the risk of damage to the device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it to carry the device or
to pull the plug out of a socket. Keep the cable away from heat sources, oil,
sharp edges or moving parts. Damaged or tangled cables increase the risk of
electric shock.
e)
If using the device in a damp environment cannot be avoided, a residual
current device (RCD) should be applied. The use of an RCD reduces the risk of
electric shock.
f)
Do not use the device if the power cord is damaged or shows obvious signs of
wear. A damaged power cord should be replaced by a qualified electrician or
the manufacturer's service centre.
g)
ATTENTION! DANGER TO LIFE! While cleaning, never immerse the device in
water or other liquids.
h)
When the device is no longer used, switch it off and pull the plug out of the
socket.
2.2.

Safety in the workplace

a)
Make sure the workplace is clean and well lit. A messy or poorly lit workplace
may lead to accidents. Try to think ahead, observe what is going on and use
common sense when working with the device.
b)
Do not use the device in a potentially explosive environment, for example in
the presence of flammable liquids, gases or dust.
c)
If you discover damage or irregular operation, immediately switch the device
off and report it to a supervisor without delay.
d)
If there are any doubts as to the correct operation of the device, contact the
manufacturer's support service.
e)
Only the manufacturer's service point may repair the device. Do not attempt
any repairs independently!
f)
In case of fire, use a powder or carbon dioxide (CO2) fire extinguisher (one
intended for use on live electrical devices) to put it out.
g)
Children or unauthorised persons are forbidden to enter a work station.
h)
Use the device in a well-ventilated space.
i)
Please keep this manual available for future reference. If this device is passed
on to a third party, the manual must be passed on with it.
j)
Keep packaging elements and small assembly parts in a place not available to
children.

Publicité

Table des Matières
loading

Table des Matières