Device Use - Royal Catering RCPKG-3600-R Manuel D'utilisation

power cord connected to the appliance must be properly grounded and
correspond to the technical details on the product label.
Disassemble the device and all its components and clean them before the first
use.
Equipotential clamp
There is an equipotential bonding terminal [9] on the back of the device, which
must be properly connected to the equipotential system before using the device.
This operation should be performed by a qualified electrician.
3.3.

Device use

1. Connect the plug of the device to an electrical outlet
2. Start the device with the ON / OFF button [6]
3. Set the required temperature using the knob [5]. The device will start heating
and the indicator [7] will be on. Heating up usually takes about 7-8 minutes.
Important:
- When used for the first time, the heating elements may emit a small amount of
smoke.
- Models with two top hotplates have a separate control panel for each hotplate.
4. When the set temperature is reached, lift the upper hotplate using the handle
[1] and coat both grill plates with a little cooking oil.
5. Place the food on the bottom hotplate [3] and press lightly with the upper
hotplate [2]. The excess oil will flow down to the grease drip tray [4]. Regularly
check the tray fill level to avoid overfilling it.
The heating elements will automatically maintain the set temperature by means
of a thermostat.
6. After the food is fried, lift the upper hotplate using the handle [1] and remove
the food with a suitable kitchen tool.
7. After use, turn the temperature control knob to "0", turn off the device,
disconnect it from the power supply and clean it.
RESET
In the event of overheating, the device will turn off automatically. If this happens:
- set the temperature control knob [5] to "0"
- set the ON / OFF button [6] to the OFF position
- allow the device to cool down and press the RESET button [11] to restart the
device.