Functions - Trix Be6/8 Série Mode D'emploi

Functions

• Built-in electronic circuit for oberation with an
conventional DC power pack, Trix Selectrix or NMRA
DCC digital.
• The mode of operation is automaticaly recognized.
• Maintenance-free, high-efficiency can motor with
bell-shaped armature.
• Triple headlights that change over with the direction
of travel.
• Analog 14 volts DC, digital 22 volts AC.
Safety Information
• Have the traction tyres replaced only ba an author-
ised dealer.
• Not suitable for locomotive controllers with pulse
width control.
• Not suitable for continuous train lighting on analog layouts.
• Not suitable for Trix ems.
• The locomotive must not be connected to more than
one power source at a time.
• Pay close attention to the safety warnings in the
instructions for your operating system.
Note for Selectrix Operation:
When a train enters a braking block that is turned on, and
enters it against the direction of travel, the indicator light
for running trains goes out in the braking block. After the
bracing block, the running light indicator comes back on.
Caution:
Control variation 4 (DCC 3) is recommended for can
motors with bell-shaped armatures, and in the standard
6
settings pulse width 1 (DCC 0) is also recommended for
these motors. There is no coverage under the warranty
for damages to motors as a result of incorrect settings.
Notes on digital operation:
• The operating instructions for your central unit
(examplare: Mobile Station) will give you exact pro-
cedures for setting the different parameters.
• The values set at the factory have been selected to
insure trouble-free operation.
• This locomotive comes from the factory programmed
for the digital address „03" (Selectrix) / „03" (DCC).
• This locomotive with the settings made at the factory
cannot be operated with opposed polarity DC power
in braking track blocks. If this feature is desired, then
you must do without conventional DC operation
(CV 29 / bit 2=0).
• Malfunctions resulting from changes to the factory
settings of the locomotive electronics are caused by
the operator and do not give grounds for complaint
under our guarantee or warranty obligaions.
• The programming for the Selectrix function is done
in the same mariner as discribed in the instructions
for the 66838 decoder.
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed
in Trix products or where Trix products have been converted in such a
way thad the non-Trix parts or the conversion were causal to the de-
fects and/or damage arising. The burden of presenting evidence and
the burden of proof thereof, that the installation of non-Trix parts or the
conversion in or of Trix products was not causal to the defects and/or
damage arising, is bome by the person and/or company responsible
for the installation and/or conversion, or by the customer.