Fit The Drawer Unit Shell To The Worktop - Garant 94 Manuel D'utilisation

4.2.3

Fit the drawer unit shell to the worktop


DE DE
EN

FR FR


IT IT


ES ES
32
Punch out the pre-drilled holes with a taper pin punch.
Take the drawers out of the
drawer unit shell. To do this,
lift the drawers twice over
the end stop.
Turn the drawer unit shell
over.
If the erection position is non-standard:
Where necessary, mark out the non-standard holes.
Drill the holes.
Place the drawer unit shell
precisely over the pre-
drilled holes and screw it
on.
If necessary, fi t the other
drawer unit shell in the
same way.