Electrical Connection; I Nstallation; Preparing For Installation; Checking The Ceiling - Gaggenau AC250121 Notice D'utilisation

en

Electrical connection

m
Warning – Risk of electric shock!
It must always be possible to disconnect the appliance
from the electricity supply. The appliance must only be
connected to a protective contact socket that has been
correctly installed.
The mains plug of the mains power cable must be easily
accessible after installation of the appliance. If this is
not possible, an all-pole isolating switch must be
integrated into the permanent electrical installation
according to the conditions of overvoltage category III
and according to the installation regulations.
The permanent electrical installation must only be wired
by a professional electrician. We recommend installing
a residual-current circuit breaker (RCCB) in the
appliance's power supply circuit.
m
Warning – Risk of electric shock!
Components inside the appliance may have sharp
edges. These may damage the connecting cable. Do not
kink or pinch the connecting cable during installation.
The required connection information can be found on
the rating plate inside the appliance; to access it, you
will need to remove the activated charcoal filter.
Length of the cable: approx. 1.30 m
This appliance complies with the EC interference
suppression regulations.
The appliance must be disconnected from the power
supply whenever installation work is being carried out.
48

I nstallation

5
P reparing for installation
I n s t a l l a t i o n
▯
We recommend a distance of at least 700 mm and a
maximum of 1500 mm. The cooking vapours are
more difficult to draw in the further away they are
from the hob.
▯
So that cooking vapours are optimally drawn in,
install the extractor hood in the middle of the hob.
▯
The installation site must be easily accessible, so
that the appliance can be accessed freely for
servicing.

Checking the ceiling

▯
The ceiling must be flat, horizontal and adequately
load-bearing.
▯
The max. weight of the appliance is 40 kg.
Notes
– Check the cut-out area for existing cables of other
appliances.
– When mounting the extractor hood, a suitable
substructure is required that is securely fastened to
the concrete ceiling.
– Do not fit the appliance directly onto plasterboard
(or similar lightweight materials) in a suspended
ceiling.
– To ensure correct installation, you must use a
material which is sufficiently stable and suitable for
both the structural conditions and the weight of the
appliance.

Preparing the ceiling

The ceiling must still be sturdy after the cut-outs have
been made.
1 Cover the hob to protect it from damage.
2 Make the cut-out in the ceiling.
3 After making the cut-outs, remove any shavings.