Samsung NX58H9950W Série Manuel Utilisateur page 66

Warming drawer
Problem
Warming drawer will not
work.
Excessive condensation
in the warming drawer.
Warming drawer or
storage drawer does not
slide smoothly or drags.
Others
Problem
The product is not level.
Possible cause
The controls are not set properly.
The Self-Clean or Sabbath
function is being used.
The oven controls have been
locked.
There is a blown fuse or tripped
circuit breaker.
The temperature setting is too
high.
The foods being warmed are not
covered with a lid or aluminum
foil.
You are trying to warm liquids.
The drawer is not properly aligned
with the full-extension roller
guide rails or nylon drawer guides.
The contents in the drawer are
too heavy.
Possible cause
The appliance has been installed
improperly.
The leveling leg(s) is (are)
damaged or uneven.
The kitchen cabinets are not
properly aligned and make the
range appear to be not level.
English - 66
Action
Reset the controls as described on
page 50.
The warming drawer will not
operate when either of these
functions is operating. Try
again after these functions are
completed or cancelled.
Unlock the controls and try again.
Replace blown fuse or reset
tripped circuit breaker.
See page 50.
Cover foods with a lid or
aluminum foil.
Liquid should not be warmed in
the drawer. Remove liquids.
Remove and replace the drawer.
(See page 60.)
Reduce the weight and/or
redistribute the contents in the
drawer.
Action
Make sure the floor is level, strong,
and stable. If the floor sags or
slopes, contact a carpenter.
Check and level the range. (See
the Installation Instructions.)
Ensure that cabinets are square
and provide sufficient room for
installation.