Samsung NX58H9950W Série Manuel Utilisateur page 62

Problem
The burners do not burn
evenly.
Very large or yellow
surface burner flames.
Surface burners light
but oven burners do not
light.
Oven
Problem
The oven control
beeps and displays an
information code.
Very large or yellow oven
burner flames.
Oven temperature is too
hot or cold.
Possible cause
Surface burner components and
caps are not assembled correctly
and level.
Surface burners are dirty.
Wrong orifice is assembled.
The oven door lock is turned on.
Gas Pressure Regulator shut off
switch is in the 'off position.
Possible cause
You have a function information
code. See the "Information codes"
chart on page 67.
The oven burner air adjustment
shutters need to be adjusted.
Gas supply is not properly
connected or turned on.
Wrong orifice is assembled.
Oven thermostat needs
adjustment.
English - 62
Action
See page 55.
Clean surface burner
components. (See page 54.)
Check the burner orifice size and
contact your installer if you have
the wrong orifice (LP gas instead
of natural gas or natural gas
instead of LP gas).
The display will show the Lock
icon. Hold the oven door open
and press the START/SET button
for 3 seconds. The oven will beep
and the Lock icon will turn off.
Call a qualified service technician.
Action
Press the OFF/CLEAR button and
restart the oven. If the problem
persists, disconnect all power to
the range for at least 30 seconds
and then reconnect the power. If
this does not solve the problem,
call for service.
Call for a qualified service
technician.
See the Installation Instructions
that came with your range.
Check the burner orifice size and
contact your installer if you have
the wrong orifice (LP gas instead
of natural gas or natural gas
instead of LP gas).
See page 45.