Table Des Matières; Meanings Of Signal Words; Intended Use; Important Safety Informations - Flex L 7-12 115 Notice D'utilisation

L 7-12 115 / L 8-11 125 / L 10-11 125 / L 14-11 125 / LE 14-11 125
Contents
Meanings of signal words . . . . . . . . . . . . 3
Important safety informations . . . . . . . . . 3
GENERAL POWER TOOL SAFETY
WARNINGS . . . . . . . . . . . . . . . . . . . . . . 4
SPECIFIC SAFETY RULES AND
SYMBOLS . . . . . . . . . . . . . . . . . . . . . . . . 6
Technical specifications . . . . . . . . . . . . . 9
Overview . . . . . . . . . . . . . . . . . . . . . . . . 10
Operating instructions . . . . . . . . . . . . . . 11
Maintenance and care . . . . . . . . . . . . . . 14
Warranty . . . . . . . . . . . . . . . . . . . . . . . . 15

Meanings of signal words

WARNING
WARNING indicates a potentially
hazardous situations which, if ignored,
could result in death or serious injury.
CAUTION
CAUTION indicates a potentially hazardous
situations which, if not avoided, may result
in minor or moderate injury, or may cause
machine damage.
NOTE
NOTE emphasizes essential information.

Important safety informations

Read and understand all of the safety
precautions, warnings and operating
instructions in the Instruction manual before
operating or maintaining this power tool.
Most accidents that result from power tool
operation and maintenance are caused by
the failure to observe basic safety rules or
precautions.
An accident can often be avoided by
recognizing a potentially hazardous
situation before it occurs, and by observing
appropriate safety procedures.
Basic safety precautions are outlined in the
" "
SAFETY section of this Instruction
manual and in the sections which contain
the operation and maintenance instructions.
Hazards that must be avoided to prevent
bodily injury or machine damage are
identified by WARNINGS on the power tool
and in this Instruction manual.
NEVER use this power tool in a manner that
has not been specifically recommended by
FLEX.

Intended use

The power tools L 7-12 115, L 8-11 125,
L 10-11 125, L 14-11 125 und LE 14-11 125
are designed
Ó for industrial applications,
Ó for dry grinding metal and stone,
Ó for use with tools and accessories which
are indicated in these instructions or
recommended by the manufacturer and
which are permitted to be used at a speed
of at least 12,000; 11,500; 11,500;
11,500; 2,800 - 11,500 r.p.m..
Not permitted are e.g. chain cutting wheels,
saw blades.
Instruction manual
3