Before You Use - Elmo TT-02 RX Mode D'emploi

BEFORE YOU USE

n Be sure to use the power cord applicable to your local power specifications. If
the product was sold in Japan, use the AC adapter sold with the product with
100 VAC and 50 or 60 Hz.
n When storing the product, do not leave it under direct sunlight or by heaters. It
may become discolored, deformed, or damaged.
n Do not place this product in any humid, dusty, salt bearing wind, or vibrating
locations.
Only use it under the following environmental conditions:
Temperature:
Humidity:
n Use a soft, dry cloth for cleaning.
Do not use any volatile solvent such as thinner or benzene.
n Do not point the camera lens directly at the sun. It may be damaged and you
may not be able to take pictures.
n Luminescent and Black Spots
T h e r e m a y b e s o m e p i x e l s t h a t d o n o t p r o p e r l y o p e r a t e d u e t o
t h e u s e o f C M O S A r e a I m a g e S e n s o r s m a d e - u p o f m a n y p i x e l s .
Though luminescent or black spots may be found on the screen, it is a
phenomenon peculiar to the CMOS Area Image Sensors and is not a
malfunction.
n Follow the guidelines below to prevent the unit from dropping or overturning.
• Use the product on a stable base, desk, or table. Do not place the product on an
unstable base or slanted surface.
• Place or wire the unit to prevent the AC adapter cord or video cable from pulling.
n Carry the product by holding the lower part of the main unit in both hands.
Never hold the product by the column or the camera head.
n Pay careful attention when using (including setting-up and storing) or
transferring the product to prevent the camera head from receiving any shocks.
n Do not bring any magnetic media such as FDs, magnetic cards, magnetic
tapes, prepaid cards, MOs, or MDs near to the magnetic strip. The data on the
recorded media could be corrupted.
n When a magnetic strip is brought close to a cathode ray tube (Braun tube), a
speaker, a CD-player, a DVD player, or a cellular phone, etc., normal operation
may be interrupted or failure may occur.
n Do not look directly into the LED light. If you look directly into it at point-blank
range, your eyes may be injured.
0°C - 40°C (32°F - 104°F)
30% - 85% (No condensation)
English