Operation; Activating And Deactivating The Exposure Cycle - MITSUI Heraeus Kulzer Translux Wave Mode D'emploi

WARNING – RISK OF EXPLOSION
Use only the charging unit, supplied with the Translux Wave, to charge the battery. Never attempt to charge the
battery using another battery charging unit or power source, due to risk of explosion and fire.
Insert the hand piece with the battery into the Translux Wave charging unit.
A beep confirms that the contacts are in the correct charging position!
IMPORTANT NOTE – Alignment key
Battery charging process.
• The Green battery status LED, on the hand piece, starts blinking.
• When the charging phase is complete, battery fully charged, the Green status LED is permanently lighted up.
IMPORTANT NOTE – Defective battery
Replace the defective battery with a new one!
WARNING
Use Heraeus Kulzer batteries only!
NOTE
When the hand piece is placed in the charging unit its functioning is inactive. The operativeness of the
" Start / Stop " button
The hand piece can be removed from the charging unit during the charging process; however, the battery
may not be fully charged and may shorten the operational duration.
6

Operation

WARNING – Check the condition of the device before starting the treatment.
Before each treatment, always make sure that the device is in proper working order and that the accessories
(light guide and protective light cone) are e cient. If anything is noted during treatment, do not carry out the
treatment and contact Heraeus Kulzer or a local authorised Customer Service agent (see paragraph 14 Service).
Do not use the device and its accessories if damage is apparent. Prior to each use of the Translux Wave
ensure that the emitted light intensity is su cient to guarantee the polymerisation. Check the light intensity by
using the light meter integrated into the charging unit (see paragraph 6.2 Measurement of the Light Intensity).
WARNING – Control of infections
First use
The accessories, light guide and protective light cone, are delivered in NON STERILE condition and must be
sterilised before being used for the first time.
Every use
Once used, the accessories, light guide and protective light cone, must be reprocessed prior to reuse,
according to the procedures described in the paragraph 8 (Cleaning, disinfection and sterilisation).
6.1

Activating and deactivating the exposure cycle

The Translux Wave can operate with two di erent exposure cycles:
Exposure with constant output:
Exposure with slowly increasing output: Soft-Start
Soft-Start
• If the hand piece is in " Sleep Mode
Start / Stop
5
beep
is prevented.
2x
GB
- 13 -