Meister MWS1100-125 Traduction Du Manuel D'utilisation Original page 72

• Ensure that the grinding tool is
correctly mounted and secured
before starting work. Allow the
machine to run for 30 sec. in a
safe position beforehand. Stop
work immediately if unusual vibra-
tions occur or other deficiencies
are noticed. In such a case, check
the machine carefully to determine
the cause.
• Never use separate reducing
sleeves or adapters to fit grinding
disks with large holes.
• With grinding tools with thread in-
sert, ensure that the thread is long
enough to take the full length of
the spindle.
• Ensure that flying sparks do not
cause danger, e.g. to other per-
sons or by igniting inflammable
substances.
• During dusty work, ensure that the
ventilation slits are kept free. If
dust has to be removed, first dis-
connect the power tool from the
power supply. Use non-metallic
objects and avoid damaging interi-
or parts of the machine.
• The disk continues to run after the
machine is switched off. Do not
lay the machine aside until the
disk has come to rest.
• Always protect eyes and ears.
72
MW-5455140-Bedien-2005.indd 72 MW-5455140-Bedien-2005.indd 72
• Other personal safety equipment,
e.g. dust mask, gloves, helmet and
clothing (e.g. apron) should also be
worn.
This device is not designed to be
used by people (including children)
with limited physical, sensory or
mental capacities or those without
experience and/or knowledge.
Children should be supervised to en-
sure that they do not play with the
device.
Safety symbols
The symbols on the housing have
the following meanings:
Do not dispose of with do-
mestic waste!
Important! Observe oper-
ating instructions!
Wear goggles.
Use ear defenders
„Tested Safety" voluntary
quality mark
Housing is double insulat-
ed
CE Mark (conformity to
European safety stand-
ards)
13.05.20 10:01 13.05.20 10:01