Arktic 233757 Mode D'emploi page 5

• Do not place articles on top of the appliance. Do not place objects with open sources of
fire (e.g. candles) on top or beside the appliance. Do not place objects filled with water
(e.g. vases) on or near the appliance.
• Never cover the appliance during use. This may cause a fire hazard.
• Do not wash the appliance with water. Washing can cause leakages and increase the risk
of electric shock.
• Do not make any additional openings on the appliance. Do not install any gadgets in the
appliance.
• Do not overload the racks inside to avoid damage. Max. loading of each rack is about 8kg.
• Do not attempt to climb up to the top of the appliance.
Installing the appliance
• The appliance should not be tipped over an angle
of 45°. After installing the appliance, wait for 2
hours before connect to the electrical power sup-
ply to switch on. The same applies if the appli-
ance is moved at a later date.
• The appliance must always be installed in a dry
environment.
Electrical components and other dangers
• No other appliances should be plugged into the
same socket as with this appliance.
• Do not place any dangerous products, such as
fuel, alcohol, paint, flammable or explosives, etc.
inside or near the appliance as it may result a
fire hazard.
• Do not store any medications in the appliance.
Grounding installation
This appliance is classified as protection class I
appliance and must be connected to a protective
ground. Grounding reduces the risk of electric
shock by providing an escape wire for the electric
• When installing, leave at least 10 cm clearance
to the rear and to the left and right for adequate
ventilation. Leaving less room for ventilation may
affect the efficiency.
• We strongly recommend to install the appliance
in a place with good natural ventilation to in-
crease ventilation properties.
• Wait about 5 minutes before switch on the appli-
ance again after the appliance has been switched
off or unplugged from the electrical power sup-
ply.
• Do not wash the appliance with water. Washing
can cause leakage and increase the risk of elec-
tric shock. No any parts/accessories can be un-
der dishwasher.
current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly
installed and grounded.
EN
5