Ditemp With Programmable Switching Outputs (Optional); Programming The Switching Outputs - SIKA DiTemp 930-40 Notice D'utilisation

DiTemp with programmable switching outputs (optional)

7 DiTemp with programmable switching outputs (optional)
WARNING! Risk of injury or material damage!
Since the measuring instruments are supplied with battery power, do not use this meas-
uring system as an active process control, as frequent switching can reduce the battery's
service life.
Applies to the explosive atmosphere version:
The switching output of the thermometer should only be operated within a certified intrinsi-
cally safe circuit.
The connector can be disconnected in explosive atmospheres due to the certified intrinsically
safe circuit. This applies to the connector of the measuring sensor and the connector of the
switching output.
The DiTemp can be optionally equipped with programmable switching contacts. This addi-
tional function allows simple "on-site" switching-point programming.
Use the supplied magnetic pen to carry out programming. The magnetic pen ensures that
accidental or unauthorised reprogramming is not possible.
Two additional symbols are visible in the DiTemp window:
Symbol SELECT :
Use this symbol to select the menu items and the digits.
Symbol ENTER :
Use this symbol to confirm the selection of menu items and
digit settings.

7.1 Programming the switching outputs

Use the programming diagram to program the DiTemp. Three levels are displayed.
Display level:
The normal measuring mode
of the thermometer is dis-
played here.
 Tap the symbol with the magnetic pen
The bar graph and the numerical display are deleted and AL 1 is displayed.
Please note:
If no entry is carried out during 20 s, the display returns to the display level without any
change to the programming.
- 24 -
Selection level:
Five possible menu items in
which settings are carried out
can be selected here.
60
°C
30
0
Entry level:
Desired values are entered
here.
© SIKA • Ba_DiTemp_en • 06/2017
DiTemp
90
120
R