SIKA DiTemp 930-40 Notice D'utilisation page 29

DiTemp
DiTemp with transmitter (optional)
Additional / modified technical data for transmitter version:
Linearity deviation
Loop voltage
Output signal
Load
Sensor break
Short circuit
Electrical connection
Applies to explosive atmosphere version:
Signal circuit with type of protection "intrinsically safe" EEx ia IIC.
Only for connection to a certified intrinsically safe circuit. Highest value: Ui = 26.4 V.
For explosive atmospheres
- by gas
- by dust
DiTemp with switching outputs (optional)
Additional / modified technical data for switching output version:
Switching temperature
Reset temperature
Switching point accuracy
Switching voltage
Switching current
Transfer resistance
Switching output
Switching cycles
Electrical connection
Applies to explosive atmosphere version:
Switching voltage
Signal circuit with type of protection "intrinsically safe" EEx ia IIC. Only for connection to a certified in-
trinsically safe circuit. Highest value: Ui = 26.4 V, Ii = 100 mA.
Auxiliary switch instruments
For explosive atmospheres
- by gas
- by dust
Technical changes reserved
15...26 V DC, protected against polarity reversal
Connector for cable connection in accordance with EN 175301-803-A,
Cable gland for d = 6.5–13 mm,
Cable cross section up to A = 1.5 mm²
Maximum surface temperature 200°C
Maximum housing temperature 125°C
Total temperature measuring range
Total temperature measuring range
default value: switching value - 5 K
48 V, +/-10 %, AC/DC 0...60 Hz
max. 100 mA (per channel)
2 x normally open contact (semiconductor relays)
For contact on-time t
approx. 5000 switching operations
Connector for cable connection in accordance with EN 175301-803-A,
Cable gland for d = 6.5–13 mm,
Cable cross section up to A = 1.5 mm²
24 V, +/-10 %, AC/DC 0...60 Hz
Certified intrinsically safety circuit required for explosive atmosphere
Maximum surface temperature 200°C
Maximum housing temperature 90 °C
< 0.1 % FS
4...20 mA
Ra =(Ub - 15 V) / 21 mA
> 21 mA (NAMUR NE43)
< 3.6 mA (NAMUR NE43)
1 K
nom. 35 Ohm
= 1 min.
on
version
Technical Data
- 29 -