Installation Details - newmotion Renault Edition Home Basic 7,4 kW Manuel D'installation

4. INSTALLATION DETAILS

The electrician is responsible for selecting a cable thickness & safety components appropriate
for the specific situation and according to regulations;
Wiring advice*
Power cable size
Earthing advice*
Required nominal
input voltage @
charge point
MCB
RCD
Load Shedding
module (7,4kW)
Load Shedding
module (11kW)
5 wires Ø 2,5mm
accessories cable
* The electrician is always responsible for selecting a cable thickness appropriate for the specific
situation and according to regulations;
** 3-phase charge point can also be connected to 1-phase. In this case the charge point can only
charge on 1-phase;
*** The electrician must select a suitable MCB with C-characteristic to match the amperage setting of the
charge point, taking into account MCB manufacturer specifications;
NOTE: The charge point can be set between 16 A and 20 A / 32 A (depending on version)
INSTALLATIEHANDLEIDING – P25
INSTRUCTION MANUAL – P25 | P25
- Wire for the maximum hardware amperage under continuous load;
- Calculate with a COS-Phi of 0.8;
- Calculate with a max allowable voltage drop over the cable of 2%;
- Use shielded cable for underground wiring
Cable grommets sizes
Maximum cable terminal block
TN-system
TT-system
Single phase**
Triple phase**
C-characteristic***
30mA Type B, or 30mA Type A (Hi, Hpi, Si) in combination with appropriate
equipment that guarantees power shutdown at DC leakage of more than 6mA
Standard CAT5 or CAT6 Ethernet cable (2 wires from twisted pair).
With a maximum length of 10 meter
Standard CAT5 or CAT6 Ethernet cable (UTP cable with RJ12 6P6C straight
connectors). With a maximum length of 20 meter
- L1, L2, L3, N + PE;
L1 & N for connecting the shunt
L2 & L3 for connecting the ON/OFF Peak signal
- Always connect PE to terminal blocks of charge point and at distribution board
- Use shielded cable for underground wiring
VERSION 0129NM02INT01
0520NM19INT03
Ø 10mm - Ø 22,5mm
10mm2 solid wire
6mm2 stranded wire with end ferrules
PE-cable (Pen conductor is not allowed)
Separately installed grounding electrode < 100
Ohm spreading resistance
230V+N +/-10% 50Hz
400V (3 x 230V+N) +/-10% 50Hz