Before First Use; Device Compatibility - Crock-Pot WeMo CSC020X Notice D'utilisation

FITTING A PLUG (FOR U.K. AND IRELAND ONLY)
This appliance must be earthed.
If the plug is not suitable for the socket outlets in your home, it can be removed and
replaced by a plug of the correct type.
If the fuse in a moulded plug needs to be changed, the fuse cover must be refitted. The
appliance must not be used without the fuse cover fitted.
If the plug is unsuitable, it should be dismantled and removed from the supply cord and
an appropriate plug fitted as detailed. If you remove the plug it must not be connected
to a 13 amp socket and the plug must be disposed of immediately.
If the terminals in the plug are not marked, or if you are unsure about the installation of
the plug, please contact a qualified electrician.
Removable lid
A
Stoneware
B
Heating base
C
Control panel
D
Restore button
E
Cool touch handle
F
Before you use your slow cooker, remove all packaging components and wash the lid and stoneware with warm soapy
water and dry thoroughly.
IMPORTANT NOTES
•
During initial use of this appliance, some slight smoke/odour may be detected. This is normal with many heating
appliances and will not recur after a few uses.
•
Some countertop and table surfaces are not designed to withstand the prolonged heat generated by certain appliances.
Do not set the heated unit on a finished wood table. We recommend placing a hot pad or trivet under your slow cooker to
prevent possible damage to the surface.
•
Please use caution when placing your stoneware on a ceramic or smooth glass cook top stove, countertop, table, or
other surface. Due to the nature of the stoneware, the rough bottom surface may scratch some surfaces if caution is not
used. Always place protective padding under stoneware before setting on table or countertop.
ASSEMBLY
1. Place the stoneware into the heating base.
2. Lower the lid horizontally down onto the stoneware.
3. Insert the power cord into the power inlet socket at the rear of the appliance.
We support iOS 7 and above and Android 4.0 and above.
PARTS
G
H
I
J
K
L

BEFORE FIRST USE

DEVICE COMPATIBILITY

-5-
Fuse should be ASTA approved to BS1362
Blue
(Neutral)
Cord storage and power inlet socket (not shown)
High temperature indicator (green)
Low temperature indicator (green)
Warm temperature indicator (amber)
Power button
Wi-Fi indicator
®
Plug should be ASTA approved to BS1363
Green/Yellow
(Earth)
3A
Fuse
Brown
(Live)
Ensure that the outer sheath of
the cable is firmly held by the cord grip