Remote Control; Using Batteries - VINCENT SV-228 Manuel D'utilisation

Point the front of the remote control directly at
the front of the appliance, making sure there are
no objects between the remote control and the
appliance.
The distance between the remote control and the
appliance should not be more than 7 m, as the
reliability of the remote control is affected beyond
this range.

Using batteries

Handling batteries incorrectly can cause battery
acid to escape or an explosion in extreme cases.
The batteries must be correctly inserted taking note
of the polarity, which is marked in the inside of the
battery compartment.
In order to make full use of the batteries' life, do
not mix new and used batteries. Make sure that
you insert batteries of the same type.
Some batteries are rechargeable, others are not
however. Take note of the precautions and instruc-
tions that are included on all batteries.
Remove the batteries if the remote control is not
going to be used for a long time.
Under no circumstances must batteries be short-cir-
cuited, taken apart or heated up.
For environmental reasons, used batteries should
be disposed of in accordance with local environ-
mental regulations and not put with domestic waste.
The remote control for this item utilizes Lithium but-
ton cells. In case of old appliance disposal put out
this battery and dispose seperately!
34

REMOTE CONTROL

Make sure that you do not point the remote control
at an angle to the appliance, as beyond an angle
of ±30° to the centre axis the appliance may not
respond as well to the remote control.
Change both batteries if the distance at which the
remote control can be used effectively decreases.
BATTERIES
Change/inserting the batteries:
1.
2.
3.
Open the battery compartmentof the remote
control by pushingout the clip and pulling out
the battery compartment.
Remove the optionally used battery and
correctly insert the new button cell, as sche-
matically shown in the battery compartment.
Close the battery compartment of the remote
control.