6-1. Routine Maintenance
Disconnect Power before maintaining.
✓ = Check
Every 3 Months
☆ Unreadable
Labels
Every 6 Months
OR
☼ Inside Unit
6-2. Overload Protection
Page 24
SECTION 6 - MAINTENANCE
⃟ = Change
✓☆ W eld Cables
☼ Sealed Bearings - No
Oil Needed
1
☼ = Clean
☆ = Replace
☼ W eld Terminals
Reference
1
Supplementary Protector CB1
CB1 protects the welding power
source control circuit from overload. If
CB1 opens, weld output drops to the
minimum of the range selected.
Press button to reset protector.
Ref. 802 927