Using The Device - Indel B RM7 Instructions D'utilisation

CO N N EC TI N G TH E D E V I C E TO TH E P OW E R S U PPLY
BAT TE RY
The device operates with a 12/24 Volt DC power supply.
Warning
To avoid drops in voltage and therefore performance, the power cable must be as short as
possible and not interrupted. Do not use additional switches, plugs or junction boxes.
Warning
When connecting the battery, ensure that the polarity is correct and protect the power supply
with a 15 A fuse.
Warning
Before charging the battery with a rapid charger, disconnect the power cord to the device and
any other fixtures. Power surges can damage the electronic system of the device.
The device is protected by an additional 5 A fuse on the power supply. If the fuse blows, simply
remove the blown fuse and insert a replacement.
Always switch off the device and disconnect it from the mains, before checking or
replacing fuses.
If the device fails to function, always check the integrity of the fuses.
The damaged (blown) fuse must be replaced with a fuse of the same technical specifications.
E R RO R LI S T
Any malfunctions are displayed with the following codes:
CO DE
Temperature sensor defective or not properly connected to the thermostat
R0.7
board.
US IN G THE D E VICE
Warning
Before initial operation of the device, clean the inside thoroughly with water and a neutral
detergent and dry with a soft cloth.
E N E RGY SAVI N G TI P S
• Place the device in a well-ventilated place sheltered from sunlight.
• Do not open the door on the device more often than necessary, as each opening causes a
change in the internal temperature.
• Do not leave the door open longer than necessary.
T YP E OF ER ROR
27