Technical Data - Zanussi ZTH485 Notice D'utilisation

Abnormally
Time to end is calculated on the basis of:
elapsing time
type, volume and dampness of laundry.
5)
on the LCD
Programme in-
Full water reservoir.
active
Drying cycle to Small laundry volume./Too dry laundry for
short selected programme.
Fluff filters clogged.
To high loading volume.
Drying cycle to
Laundry insufficiently spun.
6)
long
Particularly high room temperature - no ma-
chine fault.
1) In case of error message on the LCD (e.g. E51- only dryers with the LCD): Switch the dryer off and on. Set
programme. Press the START PAUSE button. Does not work? - inform local service and quote the error
code.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaningchapter
4) see Machine settings chapter
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).

Technical data

Dimensions (mm)
Max. depth
(with the appliance door open)
Max. width
(with the appliance door open)
Electrical connection
Drum volume
Weight of the appliance
Laundry: max. weight
Type of use
Ambient temperature
1)
Energy consumption
Annual energy consumption
Energy efficiency class
Power consumption
www.zanussi.com
Width / Height / Depth
Voltage
Frequency
Fuse
Total power
Min.
Max.
kWh/cycle
2)
Left-on mode
Automatic process; this is not a machine
fault.
3)
Empty water reservoir
PAUSE button.
Select time programme or higher drying lev-
el (e.g. EXTRA DRY ).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
Lower the room temperature if possible.
85 x 60 x 58 cm
109 mm
950 mm
230 V
50 Hz
6 A
1050 W
108 l
50,5 kg
7 kg
Household
5 °C
35 °C
2,04 kWh
251 kWh
A+
0,68
, press START
27