Zanussi ZTH485 Notice D'utilisation page 19

• Once in its permanent operating position,
check that the dryer is absolutely level with
the aid of a spirit level. If it is not, raise or
lower the feet until it is.
• The feet must never be removed. Do not re-
strict the floor clearance through deeppile
carpets, strips of wood or similar. This might
cause heat built-up which would interfere
with the operation of the appliance.
Important!
• The hot air emitted by the tumble dryer can
reach temperatures of up to 60°C. The appli-
ance must therefore not be installed on floors
which are not resistant to high temperatures.
• When operating the tumble dryer, the room
temperature must not be lower than +5°C
and higher than +35°C, as it may affect the
performance of the appliance.
• Should the appliance be moved, it must be
transported vertically.
• The appliance must not be installed behind
the lockable door, a sliding door a door with
a hinge on the opposite side to that of the
appliance in such a way that a full opening of
the dryer is restricted.
Removing transport safety packaging
Caution! Before use all parts of the
transport packaging must be removed.
1. Open loading door 2. Pull off adhesive
www.zanussi.com
strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene padding
from the machine.
Electrical connection
Details on mains voltage, type of current and
the fuses required should be taken from the
type plate. The type plate is fitted near the load-
ing aperture (see "Product description" chap-
ter).
Warning! The manufacturer declines any
responsibility for damage or injury through
failure to comply with the above safety
precautions.
Should the appliance power supply cable need
to be replaced, this must be carried out by our
Service Center.
Warning! The power supply cable must
be accessible after installing the machine.
Door reversal
To make it easier to load or unload the laundry,
the door can be reversed. The door must only
be reversed by an authorised service engineer.
Please contact your local Service Force Centre.
The engineer will carry out the door reversal at
your cost.
Special accessories
• stack kit
Available from your Service Force Centre
or your specialist dealer
These intermediate installation kits can be
used to arrange the dryer and an washing
machine (60 cm wide, front loaded) as a
space-saving washer/dryer stack. The wash-
ing machine is at the bottom and the dryer is
at the top.
19