Zanussi ZTH485 Notice D'utilisation page 24

Operating
1 2
4
EXTRA DELICATE
this function decreases the movement of the laun-
dry during the cycle. The laundry after the cycle is
more soft and loose. For synthetic programmes on-
ly.
INTENSIVE
If the laundry is still damp after a standard drying
programme, you can increase the drying result by
using the Intensive function.
LONG ANTI-CREASE
prolongs the anti-crease phase to 90 mins in total.
The laundry remains relaxed and free of creases.
BUZZER
audible confirmation of:
• cycle end
• anti-crease phase start and end
• cycle interruption
• error
TIME
after setting the Time programme. You can select a
programme duration from 10 mins to 2 hrs in 10-
minute steps.
DELAY START
allows to delay the start of a drying programme
from minimum of 30 min. to maximum of 20 hours.
Press the Delay Start button repeatedly until the
desired delay start is shown on the display
Setting child lock
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
24
3
5
changed. The child lock function locks all but-
tons and the programme selector. The child
lock can be activated or deactivated by holding
down the EXTRA DELICATE and INTENSIVE
buttons simultaneously for 5 seconds.
The icon appears in the display to indicate
that the child safety device is activated.
Any changes of drying parameters require
child lock deactivation.
The child lock cannot be deactivated in the last
phase of the drying cycle.
Changing programme
To change a programme which is running, first
cancel it by turning the programme selector dial
to . Select the new programme and press
the START/PAUSE button.
The programme can no longer be changed
directly once the programme has started. If
nevertheless there is an attempt to change the
programme on the programme knob, the pro-
gramme progress display and the maintenance
indicators flash. If an option button (excluding
the BUZZER button) is pressed,
on the display. The drying programme is not
however affected by this (laundry protection).
Drying cycle complete / removing laundry
Once the drying cycle is complete, the display
shows the anti-crease icon and flashing as
well as warning lamps: FILTER and FULL
TANK . If the BUZZER button has been press-
ed, an acoustic signal sounds intermittently for
about one minute.
The drying cycles are automatically fol-
lowed by an anti-crease phase which lasts
around 30 minutes. The drum rotates at inter-
vals during this phase. This keeps the laundry
loose and free of creases. The laundry can be
removed at any time during the anti-crease
phase. (The laundry should be taken out to-
wards the end of the anti-crease phase at the
latest to prevent creases from forming.)
1. Open door.
2. Before removing the laundry, remove fluff
from the micro-fine filter. It is best to use a
appears
www.zanussi.com