Marmitek Invisible Control 6 XTRA Guide Utilisateur page 5

4. INSTALLATION
In order to check that the system works correctly, it is advisable to
first test the set-up you had in mind. To do so, connect everything
as described below but do not stick the components securely.
4.1 LOCATING THE IR RECEIVER
Place the very small IR receiver (1) that comes with the Invisible
Control 6 XTRA |
remote control and receive the commands (max. 10 metres).
x
The most logical location for the IR receiver is, for example,
on the (TV) cabinet in which the A/V equipment is located or
near the TV.
x
You can run the cable underneath or behind, using the notch
at the back of the IR receiver housing; this allows the cable
to be hidden easily.
x
Use the self-adhesive strip which is supplied to locate the IR
receiver just about anywhere you please.
x
Experiment with the location before you stick the IR receiver
in its final position.
x
Note! The sticky strip may lead to discolouration or leave
glue residues on certain surfaces.
Invisible Control 6 XTRA |
™ so that it can be seen by your (infrared)
SMART
™
SMART
5