Work Light; Using The Hazard Flasher; Am/Fm Radio - Wagan Tech Power Dome NX 2 Manuel D'utilisation

WORK LIGHT

The Work Light is a cluster of bright LEDs located at the side of the Power Dome. The location of the
Work Light allows the light to be used while the Power Dome is being carried.
1. Set the Light Switch to the "|" position.
2. The light will illuminate.
3. Turn off the light when it is not in use.

USING THE HAZARD FLASHER

The hazard lens turns the Power Dome's light into a caution signal during roadside vehicle repair or as
a distress signal when seeking help.
1. Attach the red Hazard Flasher Lens over the light snugly.
2. Set the Light Switch to "||" for blinking mode.
Attach Hazard Flasher Lens to Light
3. Place the Power Dome in a very visible position or area.
4. Turn the light off when it is not in use.

AM/FM RADIO

The Power Dome's radio can receive frequencies in the standard AM and FM broadcast bands (AM
520–1710 kHz, FM 88–108 MHz). An extendable antenna provides adequate signal to receive all
local radio stations. When not in use, the antenna should be stored in the retracted position. This will
prevent damage to the antenna while Power Dome is being transported.
NOTE: All AM band radios are subject to receiving noise interference from electronic devices, static
lightning strikes, and some motorized equipment. If you are operating the Power Dome's inverter and
noise is being received on the AM band, turn off the inverter or change the radio to receive an FM
frequency.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2016 Wagan Corporation. All Rights Reserved.
Switch to Blinker Mode
15