Erreka IZAR Guide Rapide D'installation Et Programmation page 6

Operators without built-in release system
(IZ1C, IZ4C, IZS1, IZS4)
Unlocking for manual operation:
P
• Disconnect the power supply.
• Remove the release pin (1) and move the door
manually.
Motorised operation locking:
• Move the door manually until the crankshaft (2) is
opposite the drive block (3).
• Position the pin (1).
6
Unlocking
D186B
Installation in sectional door (IZ4DC only)
I186A
Operators with built-in release system
(IZS4D, IZ4DC)
Unlocking for manual operation:
P
• Disconnect the power supply.
• Pull the green handle (2) downwards and move the
door manually.
Motorised operation locking:
• Pull the red handle (1) downwards.

In order to use the IZAR operator (IZ4DC only)
in sectional doors, the AIZ01/02 adapter kit, as
supplied separately, must be used. For more
information on installing the IZAR operator in
sectional doors, see the instructions for this
adapter.
D186A