Accessories - Silverline 247820 Mode D'emploi

247820
Operation
WARNING: Always use adequate protective equipment, including eye
protection, respiratory and hearing protection, when working with this tool.
WARNING: DO NOT touch the moving sanding belt.
Note: ALWAYS use clamps to secure your workpiece to the workbench
wherever possible.
Switching on and off
WARNING: DO NOT switch the tool on or off whilst under load, as this
will greatly decrease the service life of the On/Off Switch (2).
1. Connect the plug to the power supply
2. Hold the tool securely, with both hands, one on the Main Handle (1) and
one on the Auxiliary Handle (4), to make sure you have full control at
all times
3. Ensure the tool is not in contact with the workpiece before commencing
with switching on
4. Toggle the On/Off Rocker Switch (2) to the 'I' position, to start the
machine
5. Toggle the On/Off Rocker Switch into the '0' position, to stop the machine
WARNING: Lift the machine off the workpiece before switching off.
WARNING: Always wait until the machine has stopped completely
before putting it down. Always disconnect from the power supply after use.
Adjusting the belt speed
• The belt speed of this power belt file can be adjusted using the Variable
Speed Dial (3)
1. Turn the Variable Speed Dial to a higher setting, to increase belt speed
2. Turn the Variable Speed Dial to a lower setting, to decrease belt speed
Note: Adjust belt speed to best suit the work carried out, and to adapt to
material requirements. Also refer to the belt manufacturer's instructions,
with regards to speed selection.
Power filing tips
• This power belt file is ideal for intricate sanding and filing tasks at places
that are difficult to access with other tools (see Fig. III)
• Move the machine over the workpiece surface, applying an even,
moderate pressure until you reach the desired surface finish
WARNING: Excessive pressure does not lead to a faster removal of
material; it will however lead to premature wear of the sanding belt, and
may cause damage to the machine. Both sanding performance and quality
depend mainly on the choice of the correct sanding belt.
• If there are still scratches on your workpiece after sanding, refer to
'Selecting the right grade of sanding belt'

Accessories

• A full range of sanding belts and accessories is available from your
Silverline stockist
Maintenance
General inspection
• Regularly check that all the fixing screws are tight. They may vibrate
loose over time
• Inspect the supply cord of the tool, prior to each use, for damage or wear.
Repairs should be carried out by an authorised Silverline service centre.
This advice also applies to extension cords used with this tool
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection
and gloves when cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause internal parts to
wear quickly, and shorten the device's service life
• Clean the body of your machine with a soft brush, or dry cloth
260W Power Belt File 13mm
• Never use caustic agents to clean plastic parts. If dry cleaning is not
sufficient, a mild detergent on a damp cloth is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through the ventilation
holes (where applicable)
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure,
or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an
authorised Silverline service centre
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
www.silverlinetools.com
7