Peg-Perego PRIMO VIAGGIO SL Notice D'emploi page 19

rotate it, press the two buttons on the handlebar and
move this to the required angle. Ensure it clicks into
position.
• Position A: the in-vehicle position;
• Position B: the position for transport by hand and for
installation on a base, stroller or chassis;
• Position C: allows the car seat to rock;
• Position D: stops the car seat from rocking;
9• To fit the hood, insert the hood attachments into the
openings on the car seat and arrange the rear part of
the hood behind the backrest.
Finally, fasten the elastic bands behind the handlebar.
10• The hood has two possible positions, opened or closed.
To remove the hood: release the elastic bands behind
the handle, lift the hood and remove it upwards.
IMPORTANT: The hood must not be used to lift
•
the car seat because it might detach.
Instructions for in-vehicle use
11• Fit the car seat with the child seated inside,
remembering to secure the child with the harness.
12• Fully lower the handlebar of the car seat (point 8 -
position A).
Slide the vehicle seatbelt into the two guides on the car
seat handlebar and buckle it, ensuring the seatbelt is
taut, as shown in the figure.
13• Take hold of the vehicle seatbelt again and pass it
behind the backrest of the car seat, inserting it into the
rear guides as shown in the figure.
Tighten the seatbelt.
Removing the soft cover
To remove the car seat cover:
• remove the hood:
• press the red button on the crotch strap buckle to release
the harness.
14• Remove the booster cushion, if present (Fig. a), and unfasten
the elastic bands from under the handlebar (Fig. b).
15• Remove the shoulder pads (Fig. a);
• Remove the straps from the backrest (Fig. b);
To remove the crotch strap, slip it through the opening
in the soft cover, lifting it as shown in the figure (Fig. c).
16• Slide off the headrest cover from the bottom first and
then, carefully, over the two sides;
BE CAREFUL NOT TO BREAK POLYSTYRENE (EPS)
PARTS.
Remove the soft cover in sequence, as shown in the
figure.
Maintenance of the padding
Brush the fabric parts to remove dust.
• When washing, closely follow the instructions stated on
the label sewn into the cover.
• Do not use chlorine bleach.
• Do not iron.
• Do not dry clean.
Do not remove stains with solvents.
• Do not tumble dry.
19