The Service Mode Menus - Sony VPL-X2000U Manuel D'installation

The SERVICE MODE Menus

Follow the steps below for entering into the SERVICE
MODE. The SERVICE MODE is available even when
only one of the four lamps for light source functions.
Accordingly, you can enter into the mode even if the
projector is in standby mode.
Confirm that STATUS is not displayed on the screen.
Operation when the projector is on
1
Press the keys on the control panel in the following
order:
ENTER key, ENTER key, V key, v key, ENTER
key
The following screen appears.
Do you wish to enter
into the SERVICE MODE?
YES:
NO:
2
Press the V key.
The projector enters into the SERVICE MODE.
3
Press the MENU key.
The SERVICE MODE select menu appears. When
the projector enters into the SERVICE MODE, "S"
appears on the upper-left corner of the screen.
S INFORMATION
fH: 1 5 . 7 kHz
fV: 1 2 0 . 0 Hz
SYNC: CPOS/– /–
ROM VER.: 1 . 0 0
OPERATION TIMER: 0 1 2 3 4 h
LAMP TIMER1: 0 1 2 3 4 h
LAMP TIMER2: 0 1 2 3 4 h
LAMP TIMER3: 0 1 2 3 4 h
LAMP TIMER4: 0 1 2 3 4 h
4
Press the V or v key to select the menu, then press
the b key or the ENTER key.
The selected menu appears.
S SERVICE SETTING
LENS CONTROL:
DIRECT POWER ON:
ON DELAY:
RS-232C/422A:
PJ COM:
5
Make setting or adjustment on the item.
For details on setting individual items, see pages
59 (GB) to 62 (GB).
58
(GB)
VIDEO
INPUT-A
O N
O F F
O F F
3 8 . 4 K
3 8 . 4 K
Operation when the projector is in standby
mode
1
Press the keys on the control panel in the following
order:
ENTER key, ENTER key, V key, v key, ENTER
key
The following message appears in the display
window of the control panel.
Enter into YES
SERVICE?
NO
2
Press the V key.
Press ON key
now.
3
Press the ON key within 5 seconds.
The projector enters into the SERVICE MODE.
4
Follow the steps 3 to 5 on the left.