Sony VPL-X2000U Manuel D'installation page 24

Before Installing the Projector
For VPLL-2014 and VPLL-2009
1 Disassemble the lens ring and attach it to the lens.
2 Attach the lens washer to the lens ring with the
four screws.
Washer
attached to
the lens
Tighten the two
screws on the
rear sides.
4
Mount the lens onto the projector.
1 Install the lens onto the projector, and push the
lens until it touches the stopper.
2 Secure the lens by tightening the four screws.
3 Fit the projections on the lens ring to the
groove on the projector.
2
3
24
(GB)
1
This side faces
2
upward when
attached to the
projector.
1
5
Tighten the two screws on the lens ring to secure
the ring firmly.
6
Attach the connector from the lens to the projector
and fix it with the cable harness.
7
Replace the cover for the lens attachment part and
tighten the screws.
Notes
• When attaching the lens, be careful not to overtighten
the screws.
• The lens scratches easily, so when handling it, always
place it gently on a stable and level surface in a
horizontal position.
• Avoid touching the lens surface.