Adjusting The Picture - Sony VPL-X2000U Manuel D'installation

Adjusting the Picture

48
(GB)
This section describes how to adjust the focus, size and vertical position of
the picture when the projector is installed on the floor. For twin/triple stack
installation, refer to the Installation Manual supplied with the SU-PJ2000
projector stand.
1
Press the PATTERN key on the Remote Commander or the control
panel to display the HATCH pattern.
2
Press the FOCUS key then the V or v key on the Remote Commander
or the control panel to adjust the focus.
"FOCUS" appears on the screen during adjustment.
3
Press the ZOOM key then the V or v key on the Remote Commander
or the control panel to adjust the picture size.
"ZOOM" appears on the screen during adjustment.
Note
If the optional VPLL-2075, VPLL-2014 or VPLL-2009 lens is
installed, you cannot adjust the zoom.
4
Press the FOCUS and arrow keys on the Remote Commander or the
control panel to adjust the focus again.
"FOCUS" appears on the screen during adjustment.
5
Press the SHIFT key then the arrow keys on the Remote Commander
or the control panel to adjust the vertical position of the picture.
"PICTURE SHIFT" appears on the screen during adjustment.
6
Press the PATTERN key again to clear the HATCH pattern.
Note
Do not look into the lens when the projector lamp is on.