GB
IE
Recommended speeds for
different drill sizes and materials:
Ø [mm]: Ø [mm]:
< 3
< 4
3 - 4
5 - 6
5
7 - 8
6 - 8
9 - 10
> 8
> 10
Checking the V-belt
1. Release the locking bolt (11) on the
gear cover (8).
2. Open the gear cover (8).
3. Check the tension of the V-belt (26).
4. The V-belt (26) is correctly tensioned
when it gives way slightly when
pressed.
5. Check the V-belt (26) for tears, cuts or
other damage.
6. Close the gear cover (8). Fasten the
locking bolt (11) on the gear cover (8).
Tensioning the V-belt
1. Release the locking bolt on the gear
cover (8).
2. Open the gear cover (8).
3. Release the retaining bolt (13) on the
motor unit (14).
4. Slide the motor unit (14) back to tensi-
on the V-belt (26).
12
5. The V-belt (26) is correctly tensioned
6. Tighten the retaining bolt (13) on the
[1/min]:
7. Close the gear cover (8). Fasten the
Adjusting the Drilling Bench
1. Release the locking handle (24).
2. Push the drilling bench (20) to the desi-
3. Pivot the drilling bench (20) to the desi-
4. Fasten the drilling bench (20) again
5. You can also adjust the tilt angle of the
Preselecting the Drilling Depth
1. Move the red arrow to the „0" position
2. Turn one of the drill lifting arms (9) an-
3. Screw the stop nut onto the desired
4. Move the spindle (6) slowly back to the
5. Adjust the drilling bench (20) until the
when it gives way slightly when
pressed.
motor unit (14) again.
locking bolt (11) on the gear cover (8).
red height.
red position.
with the locking handle (24).
drilling bench (20). To do this, release
the retaining screw (19) under the
drilling bench. Tilt the drilling bench
(20) as desired to the right or left up to
a max. of 45° and secure the drilling
bench (20) again with the retaining
screw (19).
on the drilling depth scale (3).
ticlockwise and move the spindle (6) to
the desired drilling depth.
point on the depth scale. Tighten the
fixing nut against the stop nut. Read off
the red arrow on the drilling depth sca-
le to help you.
stop position.
workpiece is resting against the drill tip.