Assembly - Parkside PTBM 500 B2 Traduction Des Instructions D'origine

GB IE
only by an authorised customer
service centre. Replace damaged
extension cables. This will ensure that
the power tool remains safe.
• Store unused power tools in a
safe place. The storage place
should be dry and lockable. This
prevents the power tool from being dama-
ged as a result of being stored or opera-
ted by inexperienced people.
• Never leave the tool before it has
come to a complete standstill. After-
running bits can cause injury.
• Do not use the power tool with
a damaged cable. Do not touch
the damaged cable and pull the
mains plug if the cable is dama-
ged while working. Damaged cables
increase the risk of electric shock.
• The device is unsuitable for processing of
foods.
• Edit not work pieces that you can not sure
retain. Especially round or uneven
workpieces.

Assembly

The bench drill is supplied disassembled.
Clean the column tube (15), baseplate
(17), drilling bench (20), vice (21) and
the drill chuck (4) beforehand, with a dry
cloth.
1. Place the column tube (15) on the ba-
seplate (17). Bolt the column tube (15)
to the baseplate (17) with the three as-
sembly srews (16) supplied. Tighten the
assembly srews (16) moderately tight
so that the threads in the baseplate (17)
do not strip.
2. Place the drilling bench (20) on the co-
lumn tube (15). Push the drilling bench
10
(20) into a lower position. Screw the
clamping bolt (24) into the clamp of the
drilling bench and fix the drilling bench
(20) in a lower position.
3. Place the vice (21) on the drilling bench
(20) and screw it with the enclosed
mounting bolts (23) tightly to the drilling
bench (20).
4. Place the motor unit (14) on the column
tube (15) and secure the motor unit
(14) with the two clamping screws (12)
to the side with the allen key supplied
(30).
5. Bolt the three drill lifting arms into the
spindle guide (9). Tighten the three hole
lifting arms with a spanner (SW 6).
6. Release the small nut from the depth
stop (3).
I. Insert this nut into the protective device
(7).
II. Put the safety device (7) on the upper
part of the drill spindle.
III. secure the safety device with the clam-
ping bolt supplied.
IV. Insert the depth stop (3) through the
hole in the fence.
V. Screw the depth stop (3) with the safety
device (7).
Centrally align the depth stop (3) into
the bore of the fence.