Accessories Connection - SCS Sentinel OPEN 2 Manuel D'installation

EN

ACCESSORIES CONNECTION

REMOTE CONTROL
> RECOgNITION Of THE REMOTE CONTROLS (maximum 12 radio accessories)
Setting up the remote controls does not suffice to make the system function correctly. You must perform
learning of the gate's travel (see page 25).
OPENING TWO LEAVES (the complete gate)
1- Take a remote control
2- Stand in front of the open electrical cabinet
3- Locate P1 and DL1
4- Press key P1 for 2 seconds then release. DL1 lights up, goes out and lights up again
5- When DL1 has lit up again, press key 1 on your remote control (front left) for 2 seconds
6- Indicator DL1 goes out: your remote control is programmed
So :
Press P1 for 2 seconds and release
DL1 On
DL1 Off
DL1 On Press Key 1 (2 seconds)
on your remote control
DL1 Off
Your remote control is programmed
start again
OPENING ONE LEAF (leaf opening first)
1- Take a remote control
2- Stand in front of the open electrical cabinet
3- Locate P1 and DL1
4- Press then release (twice) key P1.
5- DL1 lights up (indicator on steady)
6- Press key 2 don your remote control until indicator DL1 goes out
7- Your remote control is programmed
8- Now press button 2 on your remote control: only one leaf should open
So :
Press P1 (twice) with 1s. between 2 pulses
DL1 On
(the indicator is on steady)
DL1 goes out
Your remote control is programmed for pedestrian opening
start again
EN ::: 26
Indicator
LED DL1
Press key 2 on your remote control
DL1 goes out
CODES TIME PAUSE
DL1
P1 P2 P3
RV1
RL5 RL1
KEY 2
1 2 3 4 5 6 7 8 9 10 11 12 13 14
KEY 1
Keys
P1, P2 and P3
R5 R6
RL2 RL3 RL4
FS