Accessories Connection - SCS Sentinel CTR51 Manuel D'installation Et D'utilisation

EN

ACCESSoRIES COnnECtIOn

REMOtE COntROl
> RECogNITIoN oF ThE REMoTE CoNTRoLS (maximum 12 radio accessories)
Setting up the remote controls does not suffice to make the system function correctly. You must perform
learning of the gate's travel (see page 25).
OPENING TWO LEAVES (the complete gate)
1- take a remote control
2- Stand in front of the open electrical cabinet
3- locate P1 and dL1
4- Press key P1 for 2 seconds then release. dL1 lights up, goes out and lights up again
5- When dL1 has lit up again, press key 1 on your remote control (front left) for 2 seconds
6- Indicator dL1 goes out: your remote control is programmed
So :
Press P1 for 2 seconds and release
dL1 On
dL1 Off
dL1 On Press key 1 (2 seconds)
on your remote control
dL1 Off
Your remote control is programmed
start again
en ::: 30
CODES
Indicator
DL1
lED Dl1
P1
RV1
1 2 3 4 5 6 7 8 9 10 11 12 13 14
kEy 1
TIME PAUSE
Keys
p1, p2 and p3
P2 P3
R5 R6
RL5 RL1 RL2 RL3
kEy 2
RL4
FS