Connecting The Docking Station To The Network; Mounting The Camera - Abus TVAC16000C Notice D'utilisation

6.3 Connecting the docking station to the network

To connect the docking station to the internet, proceed as follows:
1. Connect the network cable to your router and the docking station.
2. Connect to the network only after you have made all the required settings on the monitor.
The network settings are described in 7.4.3.
3. After the network is set up, click on the
internet".
The power supply unit should be connected to the docking station so that a reliable power
supply is provided.

6.4 Mounting the camera

Use the camera mount to help you find a suitable place for installation. Use the drill holes to mark the surface,
and drill the holes. Insert the wall plugs supplied before you attach the bracket with the screws.
Important:
Before you begin installing, make sure that the wireless transmission range is adequate at the
site of the required installation.
To do this, first screw in the antenna supplied.
You can also swivel the mount by 90° into a particular position. First loosen the screw on the side and set the
required angle. Then tighten the screw to secure the required position.
network symbol in the sub-menu and then on "Connect to
14
English