Important Safety Information - Abus TVAC16000C Notice D'utilisation

Explanation of symbols
The triangular high voltage symbol is used to warn of the risk of
injury or health hazards (e.g. caused by electric shock).
This triangular with exclamation mark warning symbol indicates important notes in the
operating instructions which should be observed.
This symbol indicates special information bulletins and notes on the operation of the
unit.

Important safety information

All warranty claims are invalid in the event of damage caused by operating the system in
non-compliance with this user guide. ABUS USA LLC cannot be held liable for resulting
damages.
In the event of material or personal damage caused by improper operation or non-
compliance with the safety information, we cannot be held liable. All warranty claims are
voided in such cases.
This device has been manufactured in accordance with international safety standards.
Please read the following safety instructions carefully.
Safety information
1. Power supply
110 V AC voltage, 60 Hz (using a power supply unit for 5 V DC)
Only operate this device using a power source which supplies the grid voltage specified on the type
plate. If you are unsure which voltage is supplied at the installation location, contact your power supply
company. Disconnect the device from the power supply before carrying out maintenance or installation
work. The power supplies are only for indoor usage.
2. Overloading
Avoid overloading electrical sockets, extension cables and adapters, as this can result in fires or electric
shocks.
3. Liquids
Make sure that no liquids of any type are able to enter the device.
4. Cleaning
Only use a damp cloth to clean the device. Do not use corrosive cleaning materials.
Disconnect the device from the power supply while doing so.
5. Accessories
Only connect devices that are suitable for the intended purpose. Otherwise, hazardous situations or
damage to the device can occur.
6. Installation position
This device is suitable both for operation in protected outdoor areas as well as indoors. The product may
be damaged if it is dropped, even from a low height.
Install the device so that no direct sunlight can shine on the image sensor. Pay attention to the
installation instructions in the corresponding section of this user guide.
Never place the device close to heaters, stoves, other sources of heat, or in direct sunlight.
Only operate the device at locations where temperatures within the permitted ambient temperature range
of 14 °F to 122 °F prevail. Outside the predetermined temperature range operation is possible, but can
not be guaranteed.
5
English