Guarantee; Parts Subject To Wear And Tear - Solo 546 Instructions D'utilisation

Guarantee

The manufacturer guarantees problem free quality
and will cover the cost of replacing parts which are
found to be faulty in material or show
manufacturing defects within the prescribed
guarantee period after the date of purchase.
Please note that specific guarantee conditions
may differ from country to country. When in doubt,
please ask the vendor of the goods. The vendor of
the product is responsible for guarantee
applications.
We hope you will understand that we cannot be
liable for damage resulting from these causes:
• Non-compliance with operating instructions.
• Neglecting required maintenance and repair
jobs.
• Damage caused by improper carburettor
adjustment.
• Wear from normal use.
• Obvious overload by continuously exceeding
the upper performance limit of the product.
• Using non-approved tools.
• Use of force, improper treatment, misuse and
accidents.
• Damage from excessive heat due to dirt build
up around the cooling fan housing.
• Attempted adjustments and repairs by non-
qualified persons.
• Use of unsuitable spare parts or non-original
parts if such parts are the cause of the
damage.
• Use of unsuitable or stale fuel.
• Damage caused by using the product in the
hire or rental industry.
Normal cleaning, adjustments or maintenance jobs
cannot be claimed as part of the guarantee.
All guarantee work must be carried out by a
service centre authorized by the manufacturer.
Maintenance and repair
Maintenance and repair of modern motorized
devices, as well as their safety-relevant
assemblies, require qualified, specialized training
and a workshop equipped with special tools and
test devices.
Thus SOLO recommends that you have a
specialized SOLO workshop carry out all work that
is not described in these operating instructions.
Your SOLO specialist has the required training,
experience, and equipment at his disposal to
provide you with the most cost-effective solution
and can help you in many ways with advice and
service.
Guarantee; Parts subject to wear and tear
Replacement parts
Dependable operation and the safety of your
device also depend on the quality of the
replacement parts that you use. Use only original
SOLO replacement parts.
Only original parts come from the production of the
device and thus guarantee the highest possible
material quality, dimensional accuracy, function,
and safety. Original replacement parts and
accessory parts are available from your dealer. He
also maintains the requisite replacement part lists
to determine the required replacement part
numbers, and he is constantly provided with
information concerning detail improvements and
innovations in the replacement part offering.
Please note as well that guarantee performances
from SOLO are not possible if parts other than
SOLO original parts are used.

Parts subject to wear and tear

parts are subject to application-specific
Various
wear or to normal wear and must be replaced in
good time if necessary. The following parts are
subject to normal wear and are not covered by the
manufacturers guarantee:
• Blade and blade fixing
• Friction pads
• Air filter
• Spark plug
• Fluids, such as engine and gearbox oil
• Drive belts and freewheel 5038437 / 5038438
on lawnmowers with self-drive
In conformance with the product liability law we
want to clearly point out that we are not liable for
any damages which may occur due to improper
handling, or repair. Furthermore, we are not
responsible for any damage that may occur if
replacement parts other than SOLO replacement
parts, or parts that were not authorized by SOLO,
have been used. In addition we are not liable for
any damage that may occur if repair work was
performed by any source other than the Customer
Service or an authorized Service Center. This
liability exclusion applies also to accessories and
supplemental parts.
ENGLISH 17