Electrical Connection; Wiring Diagram - Anselmo Cola VISION HR Manuel D'installation, D'utilisation Et D'entretien

2.6 Electrical connection

Connect one end of the power cable the wall socket.
The voltage supplied by the system must match that specified on the stove dataplate and in the technical data
section of this manual.
Plug the device power cord must be connected only AFTER the end of the installation and assembly of the device
and must remain accessible.
During stove idle periods it is advisable to remove the power cable.
- Make sure the electrical system is equipped with an earth and differential switch in accordance with the
current Regulations.
- The power cable must never touch the stove exhaust pipe.

2.7 Wiring diagram

FUME FAN
ENCODER
AUGER
EXCHANGERS
FUME FAN VENTILATORE
FUMI
TSP= PELLET SAFETY THERMOSTAT
DEP = PRESSURE SWITCH
* = OPTIONAL COMPONENT
2.8 Emergency
Suitable fire-prevention devices should be arranged for any eventuality.
In case of a fire, proceed as follows:
- Immediately disconnect the plug.
- Extinguish the fire using suitable fire-extinguishers.
- Call the fire department immediately.
- Do not use jets of waters to extinguish the fire.
EXTERNAL
THERMOSTAT*
FUME
PROBE
IGNITER
ROOM
PROBE*
GROUND
37
AIR FLOW METER
VISION HR