Accessing The Network Camera For The First Time - Abus TVIP21502 Manuel Utilisateur

4.7 Accessing the network camera for the first time

The network camera is accessed for the first time using the IP Installer.
After the installation wizard is started, it searches for all connected EyseoIP network cameras and video
servers in your network.
The program is found on the supplied CD-ROM. Install the program on your PC and then run it.
If a DHCP server is available in your network, the IP address is assigned automatically for both the PC /
laptop and the network camera.
If no DHCP server is available, the network camera determines a free IP address from the 192.168.1.2–
192.168.1.254 range independently. Your PC system must be located in the same IP segment in order to
establish communications with the network camera.
The standard setting for the network camera is "DHCP". If no DHCP server is in operation in
your network, then we recommend setting the IP address manually to a fixed value following
initial access to the network camera.
74