Installation; Pairing The Camera And The Monitor; Mounting The Camera - Abus TVAC14010A Notice D'utilisation

Installation

Pairing the camera and the monitor

To connect a camera with the monitor, proceed as follows:
1. Connect the camera and the monitor to the power supply units.
2. In the monitor menu, select "Camera settings", then the required camera. Now select the "Pair
camera" option and press the menu button.
3. Then press the PAIRING button on the camera cable. The green link LED starts to flash.
4. Once the connection is established, the link LED on the camera illuminates for 2 seconds and
then goes out. The message "Pairing successful" appears on the monitor.
Important:
Please note that the connection can take up to 60 seconds.

Mounting the camera

Use the camera mount to help you find a suitable installation location. Now mark the drill holes on the
surface, and drill the holes. Insert the screw anchors supplied before you attach the mount with the
screws.
Important:
Before you begin installing, make sure that the wireless transmission range is adequate at the
site of the required installation.
To do this, first screw in the antenna supplied.
23
English