Abus TVIP21502 Manuel Utilisateur page 111

Motion detection
Time between two event triggers:
Detection range:
Detection type:
Switching input
Time between two event triggers:
Switching input 1:
Interval process
Triggering every xx hours xx min.:
Upon restart
The event is executed upon restart of the camera.
ICR filter
Time between two event triggers:
ICR filter mode:
Storage space warning
The storage space monitoring of the SD card is used as the trigger.
Network connection inactive
Loss of the network connection is used as the trigger. The action is executed upon reestablishment of the
network connection.
IP notification
Change of the IP address is used to trigger the change. Check the option that is to be monitored (DHCP,
FixedIP, PPPoE)
Time definition in seconds (up to 999 seconds) before a possible
next event is registered by the camera.
Selection of a previously configured motion range (configuration using the "Motion
detection" item).
Selection of the detection time point
Start: At the beginning of the event
Stop: At the end of the event
Time definition in seconds (up to 999 seconds) before a possible
next event is registered by the camera.
Click here to activate the switching input as the trigger. The following switching
thresholds are available:
Active: Upon increasing edge of the switching input
Inactive: Upon declining edge of the switching input
The shortest triggering interval is 1 min. The longest triggering
interval is 23 hours and 59 min.
Time definition in seconds (up to 999 seconds) before a possible
next event is registered by the camera.
The event can be triggered by switching into day or night mode.
111